UNE ENV 12633: Determination of slip resistance of polished and unpolished pavements
Menu
UNE 48250: Abrasion Resistance. Taber Method
Results obtained after testing with the Taber method of 250 cycles with abrasive wheels made of resilient material (CS107) and subsequent extrapolation to 1,000 cycles. Weight of 1,000 g on each arm of the abrasimeter.
DIN 52617: Determination of the coefficient of water absorption in building materials
Results obtained after testing with a Karsten graduated tube of 25.5 mm internal diameter. The absorption reading is made at 10 and 60 min after the inside of the tube is filled with water.
UNE ENV 12633: Determination of slip resistance of polished and unpolished pavements
Results obtained after testing with a pendulum (type 48-B0190/2 CONTROLS) made up of a type 4S rubber skid that rubs against the surface and on a C scale. Record of measurements of five successive readings that do not differ by more than 3 units between them , as well as five other measurements, made after turning the specimen 180º.
*NOTE: Anti-slip behavior to be customized by the client in any of our SmartCOVER systems (CLASSIC, ECO and AQUA+).).
UNE EN 14527:2006 + A1: 2010 Apdo.8.2.: Chemical resistance
This test determines the resistance of finishes to certain chemical products. After depositing the product on the surface and keeping it covered with watch glasses for 2 hours, the product must be removed without leaving a permanent stain.
*NOTE: Test carried out on the three SmartCOVER systems (CLASSIC, ECO and AQUA+) with the same result.
UNE EN 13529: Determination of resistance to chemical attacks
This test determines the resistance of finishes to chemical attacks by directly exposing the surface to the following products for 7 days:
*NOTE: Test carried out on the three SmartCOVER systems (CLASSIC, ECO and AQUA+) with the same result.
UNE 127007: Impact resistence
This test determines the resistance to impact by means of the successive fall of a 1 kg steel ball on the same point, increasing the height by 5 cm in each fall. The drop height set for this standardized test is 1 m.
*NOTE: Test carried out on the three SmartCOVER systems (CLASSIC, ECO and AQUA+) with the same result.
UNE EN 1015-12: Determination of the adhesion resistance of hardened mortars applied on supports
Results obtained after a break of the adhesive type, that is, produced in the area between the mortar and the support. The value of the test is the resulting average of the values obtained in 5 different repetitions on the same sample.
UNE 67101: Determination of surface scratch hardness
This test determines the scratch hardness of the surface by applying the Mohs scale method.
*NOTE: Test carried out on the three SmartCOVER systems (CLASSIC, ECO and AQUA+) with the same result.
UNE 127004: Freezing test
The samples are subjected to 10 temperature cycles of 24 hours (100 ºC – 12 hours and -15 ºC – 12 hours).
*NOTE: Test carried out on the three SmartCOVER systems (CLASSIC, ECO and AQUA+) with the same result.
